3.2 Functions for server control

This section describes the functions that you can use on the servers in a hot-standby configuration.

Organization of this section

• 3.2.1 Monitoring a server in the monitor mode (for the active server)

• 3.2.2 Monitoring a server in monitor mode (for the standby server)

• 3.2.3 Grouped-system switchover achieved by grouping servers

• 3.2.4 Controlling the server switchover order

• 3.2.5 Multi-standby for providing multiple standby systems

• 3.2.6 Locking servers to prevent concentration of the processing load after the hot standby operation

• 3.2.7 Performing start retries during hot standby processing

• 3.2.8 System operation linked with JP1

• 3.2.9 Hot-standby switchover in the online serverless mode

To Page Top