2.1 Hot-standby configurations

HA Monitor enables you to choose from the hot-standby configurations described below. This section explains examples of the configurations. For details about the characteristics of each configuration, see 5.2 Evaluation of hot-standby configuration.

Note that if you use SCSI reservation for shared disk, reset paths cannot be used.

Organization of this section

• 2.1.1 1-to-1 switchover configuration

• 2.1.2 Mutual hot-standby configuration

• 2.1.3 2-to-1 switchover configuration

• 2.1.4 Multi-standby configuration

• 2.1.5 Cluster hot-standby configuration

To Page Top