6.6 Specifying the KVM-based virtualization environment settings

Configure KVM for use with HA Monitor.

For an example of a hardware configuration where KVM is used for virtualization, see (5) VMware ESXi-based or KVM-based virtualization configuration.

The following figures show an example single-path configuration and an example multi-path configuration in a KVM-based virtualization environment. For details about Setting 1 in the figure, see 6.6.1 KVM settings (Setting 1). For details about Setting 2 in the figure, see 6.6.2 Multipath control (DMMP) settings (Setting 2).

Figure 6‒8: Single-path configuration (KVM-based virtualization environment)

Figure 6‒9: Multipath configuration (KVM-based virtualization environment)

Organization of this section

• 6.6.1 KVM settings (Setting 1)

• 6.6.2 Multipath control (DMMP) settings (Setting 2)

To Page Top