15.5.1 What to check if the adbgetcst command terminates abnormally
To check and determine the necessary action to take:
-
Check the specified command for any error.
Check if the following messages were issued:
-
KFAA50225-E
-
KFAA96606-E
If either of these messages was issued, an error was detected in the specified command options or in the cost-information collection option. Check and correct the command options and cost information collection option, and then re-execute the adbgetcst command.
If neither of these messages was issued, go to the next step.
-
-
Check if the KFAA80204-I message was issued.
If the KFAA80204-I message was issued with return code 0, collection or deletion of cost information has been completed. No action is needed.
If the KFAA80204-I message was not issued with return code 0, the appropriate action must be taken according to the processing that terminated abnormally. The following table shows the relationship between the processing resulting in abnormal termination and the action to be taken.
Table 15‒4: Relationship between the executed processing and the action to be taken No.
Processing resulting in abnormal termination
Scope of processing
Action
1
Collection of cost information
Specific table
See 15.5.2 If the command terminated abnormally while collecting cost information for a specific table.
2
All tables
See 15.5.3 If the command terminated abnormally while collecting cost information for all tables.
3
Deletion of cost information
Specific table
See 15.5.4 If the command terminated abnormally while deleting cost information for a specific table.
4
All tables
See 15.5.5 If the command terminated abnormally while deleting cost information for all tables.