This section explains the commands of the MCF online tester for running a test on an application. For the format and rules of the operating commands, see the manual OpenTP1 Operation.

Table 9-3 lists the operating commands used for running tests on an application.

Table 9-3 Operating commands for running tests on an application

Command name	Function
mcfaulsap	Display of test mode information for an application
mcfauaps	Start of an application test
mcfauape	Termination of an application test

Organization of this section

9.3.1 mcfaulsap (display of test mode information for an application)

9.3.2 mcfauaps (start of an application test)

9.3.3 mcfauape (termination of an application test)