Error conditions and causes

Table 6-1 lists the types of errors that may occur with the online tester and their probable causes.

Table 6-1 Online tester errors and causes

Error	Cause	Manual reference
Online tester command does not terminate normally.	No online tester definition in system definition.	6.1.2 (1)
	Incorrect option or command argument.
	File for command execution cannot be accessed.
UAP trace information not collected.	No test target specified in system definition.	6.1.2 (2)
	Zero specified in max_trace_file_size operand in the system definition.
	Zero specified in UAP_trace_max operand in the system definition.
Send messages not collected.	No test target specified in system definition.	6.1.2 (3)
	Zero specified in max_message_file_size operand in the system definition.
	Number of send messages exceeds the upper limit.
No send data collected for interactive service requests.	Output of send data not defined in the system definition.	6.1.2 (4)
Test UAP does not start.	Test user ID not set.	6.1.4 (1)
Test UAP does not start.	No test target specified in system definition.	6.1.4 (1)
UAP does not start in non-test mode.	Specified as a test UAP in the system definition.	6.1.4 (2)
dc_rpc_open function in a test UAP returns an error.	No online tester definition in the system definition.	6.1.4 (3)
Test UAP restarted with _uto as the test user ID.	Conflict in UAP status control between the OpenTP1 system and the online tester.	6.1.4 (4)
Test UAP does not recover after abnormal termination.	Test UAP interlocked to the debugger.	6.1.4 (5)
Debugger-interlocked UAP frequently causes a time-out error.	Incorrect value specified for the monitoring time in the user service definition.	6.1.4 (6)