mmm received the negative acknowledge from the terminal. connection name=aa....aa logical terminal name=bb....bb reason code=(cc....cc,dd....dd,ee....ee) state code=ff
- mmm: MCF identifier
- aa....aa: Connection name
- bb....bb: Logical terminal name
- cc....cc: Termination code
- 03000001: A line error occurred.
- 05000003: A contention occurred.
- dd....dd: Detail information
- ee....ee: Action code
- ff: Status code in the rejection response received from the terminal
- 01: The security key is locked.
- 02: The main device cannot be used (the power is off or the device is being initialized).
- 03: There are no printer resources (page overflow, no auxiliary printer, or no main printer).
- 04: Permanent error on the main device (hardware error)
- 05: Permanent error on an auxiliary device (hardware error)
- 21: Contention state (during key input)
- 22: The main device is busy (test mode, waiting for a printer for local printing, or processing graphics).
- 23: The main device is busy processing LBP graphics or is executing a job.
- 24: The screen is damaged (temporary error or end of test mode).
- 25: Resources cannot be used (the host was using the printer when local printing was requested).
- 26: A request to end the chain was issued (the operator canceled the printing being performed on the printer).
- 27: Data cannot be received (a rejection request for the BID was sent or data is being used for local copy).
- 28: An error that requires operator intervention, such as a paper-out condition, open cover, or HOLD-PR, occurred on a printer connected to a display terminal.
- 29: An error that requires operator intervention, such as a paper-out condition, open cover, or HOLD-PR, occurred on a printer terminal.
- 2a: Contention occurred.
- c1: Parameter error
- c2: Unsupported function (invalid command)
- c3: An on-demand gaiji was detected.
- S: Continues processing or ends the session.
- O: Contact the OpenTP1 administrator.
- Countermeasure: Determine the cause of the error by referring to the detail information for the reason code, and then take appropriate action based on the action code. For details about the detail information and action codes, see the detail information and action codes provided for the KFCA28405-E message.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.