OpenTP1 Version 7 Messages
mmm error occurred in the session. connection name=aa...aa logical terminal name=bb...bb reason code=(cc....cc,dd....dd,ee....ee)
Detail information | Meaning |
---|---|
71010003 | Data exceeding the receive buffer size was received. |
71010004 | The send/receive buffer could not be acquired. |
7101000a | Shared memory was insufficient. |
7101000e | A timeout of the term reception monitoring timer occurred after a rejection response was sent. |
7101000f | A timeout occurred during monitoring of the reception of response messages for the READ ALL command. |
71010010 | A timeout occurred during monitoring of the reception of gaiji request messages. |
71010011 | A message send request occurred on a video terminal equipped with the component printer. |
7101ffff | An internal contradiction occurred. |
72000000 | A line error occurred. |
73000000 | An internal error was detected in TP1/NET/C/S560. |
740000** | A rejection response was received for the sent request messages. The status code of the received rejection message is set in **. For details of the status codes, see the status codes in the KFCA28432-E message. |
Detail information | Meaning |
---|---|
00020000 | There is no input device. |
08310000 | The power of the main device was turned off, or the connection with the terminal was lost. |
Action code | Description |
---|---|
xxxxxx01 | No particular action is required. |
xxxxxx02 | If necessary, restart the session by logging on from the terminal. |
xxxxxx03 | Check the buffer size specified in the buffer group definition of the MCF configuration definition, re-create the MCF configuration definition, and then restart OpenTP1. |
xxxxxx05 | Determine the cause of the error by referring to the detail information and then correct the source of the error. If there are no system problems, start the session by logging on from the terminal. |
xxxxxx08 | Determine the cause of the error by referring to the detail information. After correcting the error, wait at least 10 seconds, and then re-establish the connection. |
xxxxxx0c | Collect the console log, trace file, and dump information, and then contact maintenance personnel. If necessary, enter the connection establishment command to re-establish the connection. |
xxxxxx0d | Check the number of buffers specified in the buffer group definition of the MCF configuration definition, re-create the MCF configuration definition, and then restart OpenTP1. |
xxxxxx0e | Re-estimate the amount of memory required for OpenTP1 operation, increase the amount of virtual memory, and then restart the system. |
xxxxxx10 | Determine the cause of the error by referring to the detail information and then correct the source of the error. If there are no system problems, enter the connection establishment command to re-establish the connection. |
xxxxxx12 | Determine the cause of the timeout, and then make the necessary corrections. After making the corrections, wait at least 10 seconds and then start the session by logging on from the terminal. |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.