mmm error occurred while exchanging the extended host access message. connection name=aa...aa logical terminal=(bb...bb,ccc,dd...dd) maintenance information=(e,fff,gg...gg,hh...hh,iiiiiiii,jj...jj)

mmm: MCF identifier

aa...aa: Connection name

bb...bb: Logical terminal name

ccc: Logical terminal type

any: any type

dd...dd: Operation mode

extend: Extended mode

noedit: Non-editing mode

e: Error identification

A: Invalid application name specified

C: Code conversion failed

E: UAP terminated without sending a response.

N: NOTIFY received

O: Number of started UAPs exceeds the limit.

S: Sequence error

T: A noans-type UAP is started when receiving a message that requires response.

fff: Matrix identification

ud1: User data exchange matrix (noans-type)

ud2: User data exchange matrix (ans-type)

ud3: User data exchange matrix (cont-type)

udc: User data exchange matrix

gg...gg: Matrix status code (maintenance information)

hh...hh: Matrix event code (maintenance information)

iiiiiiii: Exception code

00842232: Invalid application name

00842332: Number of concurrently started UAPs exceeds the number of extended mode logical terminals.

00843000: User data or NOTIFY message is received for an inactive UAP.

00843100: When a message that requires response was received from the host, the OpenTP1 system started a noans-type UAP, or the UAP terminated without sending a response.

00c20121: Invalid send message (invalid subcommand)

00c20f20: Invalid send message (invalid length)

00c20f30: Invalid send message (invalid length in UAP parts)

00c20f40: Invalid send message (invalid length of user data part)

00c20f50: Invalid send message (invalid length of exception code part)

00c21022: Invalid send message (invalid flag value)

00c21031: Invalid send message (invalid id of UAP parts)

00c21041: Invalid send message (invalid id of user data part)

00c21051: Invalid send message (invalid id of exception code part)

00c30a00: Received data violates the transfer sequence.

Other than above: The cause of the error cannot be determined.

jj...jj: Error code

S: Terminates exchange of extended host access messages.

O: Take action according to the error identification as shown below.

A or T: Check the application name specified by the host and application definition, and remove the cause of the error. Then, retry.

E: If the UAP needs to send a response message, remove the cause that terminated the UAP without sending a response message, and then retry.

O: Check the mcftalcle definition command in the MCF communication configuration definition for the number of extended mode logical terminals defined and the number of UAPs to be started concurrently by the host, and remove the cause of the error. Then, retry.

N, S, or C: Contact the OpenTP1 administrator.

Countermeasure: When the error identification is N, S, or C and the cause of the error cannot be determined, obtain maintenance information and contact the OpenTP1 administrator.