stop of node aaaa: host bb...bb could not be checked. status: cc...cc

aaaa: Identifier of node whose stop status could not be checked

bb...bb: Host name specified in the multinode physical definition of the OpenTP1 node whose stop status could not be checked

cc...cc: Current node status

START: Start processing in progress

NOTUP: It is impossible to communicate because of any one of the following statuses:

• Node setup is necessary.
  (dcsetup not yet executed, dcsetup re-execution required)
  
• Multinode physical definition error (node unregistered, invalid host name or port number)
• Communication error (host power not turned on, network failure)

ONLINE: In online status

STOP: Termination processing in progress

TIMEOUT: Timeout occurrence

CANNOT STOP: The termination processing failed. To determine the cause of the failure, perform login for the host having the OpenTP1 node where the problem occurred, then execute the dcstop command.

O: Examine the status of each node by using the dcndls command. If necessary, execute the stop command for the relevant node.