OpenTP1 Version 7 Messages
KFCA04609-W (E)
cannot terminate node aaaa: host bb...bb. reason: cc...cc
- aaaa: Identifier of the OpenTP1 node which could not be terminated
- bb...bb: Host name specified in the multinode physical definition of the OpenTP1 node which could not be terminated
- cc...cc: Cause code indicating unsuccessful termination
- NETDOWN: Network failure
- DOWN: Stop or down
- START: Start processing in progress
- NOTUP: No setup
- STOP: Termination processing in progress
- TIMEOUT: Timeout occurrence
- INSTALL: N is specified in the multi_node_option operand of the system common definition for the relevant node, or TP1/Multi is not installed.
- S: Terminates the termination processing for the relevant node but continues processing for other nodes.
- O: Remove the cause of the error, then terminate OpenTP1 again.
- NETDOWN: Examine the cause of the network failure.
- INSTALL: Check that Y is specified in the multi_node_option operand of the system common definition for the environment in which TP1/Multi is installed. If TP1/Multi has not yet been installed, install it.
- NOTUP: Check if the multinode physical definition is incorrect or a communication error has occurred. When the multinode physical definition is correct and no communication error has occurred, re-execute the dcsetup command.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.