OpenTP1 Version 7 Messages
KFCA04606-W (S)
start of node aaaa: host bb...bb could not be checked. status: cc...cc
- aaaa: Node identifier whose start status could not be checked
- bb...bb: Host name specified in the multinode physical definition of the OpenTP1 node whose start status could not be checked
- cc...cc: Current node status
- DOWN: Stop or down
- START: Start processing in progress
- NOTUP: Communication is impossible due to one of the following causes:
- The node is not registered in the operating system (dcsetup command is not executed or re-executed).
- Multinode physical definition error (Node is not registered or error in host name or port number)
- Communication error (Host is turned off or network error occurred)
- STOP: Termination processing in progress
- TIMEOUT: Timeout occurrence
- CANNOT START: Start processing failed. To find out the cause, log in to the host where the faulty OpenTP1 node exists, then execute the dcstart command.
- O: Examine the status of each node by using the dcndls command. If necessary, execute the start command again.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.