OpenTP1 Version 7 Messages
KFCA04605-W (S)
node aaaa : host bb...bb cannot be activated. cause: cc...cc
- aaaa: Identifier of the OpenTP1 node which could not be activated
- bb...bb: Host name specified in the multinode physical definition for the OpenTP1 node which could not be activated
- cc...cc: Cause code indicating unsuccessful activation
- NETDOWN: Network failure
- START: Start processing
- NOTUP: Communication is impossible due to one of the following causes:
- The node is not registered in the operating system (dcsetup command is not executed or re-executed).
- Multinode physical definition error (Node is not registered or error in host name or port number)
- Communication error (Host is turned off or network error occurred)
- ONLINE: In online status
- STANDBY: In standby status
- STOP: Termination processing in progress
- TIMEOUT: Timeout occurrence
- INSTALL: N is specified in the multi_node_option operand of the system common definition for the relevant node, or TP1/Multi is not installed.
- S: Terminates the start processing of the relevant node but continues processing for other nodes.
- O: Remove the cause of the error, then reactivate OpenTP1.
- NETDOWN: Determine the cause of the network failure.
- INSTALL: Check that Y is specified in the multi_node_option operand of the system common definition for the environment in which TP1/Multi is installed. If TP1/Multi has not yet been installed, install it.
- NOTUP: Check if the multinode physical definition is incorrect or a communication error has occurred. When the multinode physical definition is correct and no communication error has occurred, re-execute the dcsetup command.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.