archive service of journal aaaa(bbbbbbbb) has not been completed but continues processing. reason code=cccc, transmission completion position=dd...dd, ee...ee

aaaa: Type of the journal file service to be archived (String of up to four alphanumeric characters)

bbbbbbbb: Resource group name of the journal file to be archived (String of up to eight alphanumeric characters)

cccc: Reason code (Number of up to four digits)

The countermeasures according to the reason code are shown in the table below.

dd...dd: Generation number of the file for which transmission was completed (Up to eight hexadecimal numbers)

ee...ee: Number of the block for which transmission was completed (Up to eight hexadecimal numbers)

S: Stops the archive service and continues system termination.

O: Refer to the reason code list and take appropriate action.

Reason code	Meaning	Countermeasure
2008	Data transfer was not completed. The possible causes are: Data transfer amount was vast and all the data could not be transferred within the specified time. Error occurred on hardware such as Ethernet board or cable. Failed OpenTP1 node at archive destination is not restarted or was started normally.	Unload the untransferred journal. If the system has terminated normally, transfer the unload data to the archive node and merge it with the unload journal in the archive journal. Examine the cause by applying the following procedure and take appropriate action: Check the connection status of the node by using an operating system command. Check the OpenTP1 node status at archive destination by using an OpenTP1 command. Check the status of the connected node by using the jnlarls command on the OpenTP1 node at the archive destination.
2009	Connection with archive node could not be canceled.	Take action according to previously output message KFCA04138-E.