cannot create a server process. server: aa...aa, reason code=bb...bb (cc...cc)

The creation of a server process failed upon scheduling the server.

aa...aa: Name of the server on which a server process cannot be created. (Up to eight alphanumeric characters)

bb...bb: Reason code for the server process creation failure. (Up to ten digits)

The table below lists the reason codes and their corresponding countermeasures.

cc...cc: Internal code. (Up to a 10-digit integer)

S: Postpones the scheduling of the server. If the reason code is 99, OpenTP1 may terminate abnormally.

Countermeasure: Proceed as indicated by the reason code.

To abort the processing, stop the server forcibly.

This message is output approximately every ten seconds. This message can only contain the names of five servers. Therefore, if the names of five servers are output in the message, there may be other servers in the same state. Check this point.

Reason code	Meaning	Countermeasures
1	The maximum process count specified for the system or OpenTP1 has been reached.	Reduce the number of processes being executed. Alternatively, review the maximum process count.
2	Insufficient memory in the system or OpenTP1	Check the OS memory setting to eliminate the problem of insufficient memory. If the problem cannot be corrected, contact maintenance personnel.
3	Timing error	If the error fails to be recovered despite a relatively long time elapsing, contact the maintenance personnel.
99	System error