cannot terminate server aa...aa. reason code=bb...bb

An error occurred while terminating the server.

aa...aa: Name of the server that cannot be terminated. (Up to eight alphanumerics)

bb...bb: Reason code indicating the contents of error. (Up to ten numerals) The table below shows the reason codes and countermeasures.

S: Discontinues the server termination processing.

If this message appears when the dcstop command is being executed, the corresponding server is ignored and the system's termination continues.

O: If it is necessary to terminate the corresponding server, use the server stop command (dcsvstop -f) to bring the server to a forced stop. If this message appears when the dcstop command is being executed, delete the corresponding server process after the system is terminated.

Countermeasure: Take corrective action referring to the reason code list.

Reason code	Meaning	Cause or action
1	Corresponding server not started	The specified server or service group has not been started.
2	Timing error	The scheduler is not started or it is about to terminate.
3	Communication failure	If there is a previous output of failure messages, take corrective action in accordance with them.
4	Different program version	Take corrective action after checking the versions of all libraries in OpenTP1.
5	Insufficient memory	If the KFCA00855-E message showing STATIC_SHMPOOL or DYNAMIC_SHMPOOL as the area type was output immediately before this message, check and correct the memory size specified in the system environment definition. For other cases, take countermeasures according to the message that was output before this message.
6	Definition analysis error	If there is a previous output of failure messages, use them to take corrective action.