OpenTP1 Version 7 Messages

[Contents][Index][Back][Next]

KFCA00698-W (E)

(aa....aa: bb....bb) cc....cc is specified for the name_audit_conf operand, and no value or a value less than 181 is specified for the name_audit_interval operand, so we recommend specifying "N" for name_rpc_control_list.

Either specify 1 or 2 in the name_audit_conf operand in the name service definition and then either specify 180 or smaller value in the name_audit_interval operand, or else omit this operand. In this case, since the processing uniquely performed by the name service (checking whether the nodes registered in the RPC suppression list are available) is unnecessary, we recommend that you specify N in the name_rpc_control_list operand.
For details about the message types and problem identification codes, see the explanation of the definition check command in the manual OpenTP1 System Definition.
aa....aa: Message type
bb....bb: Problem identification code
cc....cc: Value specified in the name_audit_conf operand
S: Continues processing.
Countermeasure: Specify N in the name_rpc_control_list operand in the name service definition.