(aa....aa: bb....bb) No value or "0" is specified for the name_audit_conf operand, so if "N" is specified for the name_rpc_control_list operand, the name service will not delete a node from the list of RPC-suppressed nodes until it receives a message from that node.
- If the name_audit_conf operand is not specified in the name service definition, or if the value specified for it is 0, do not specify N in the name_rpc_control_list operand.
For details about the message types and problem identification codes, see the explanation of the definition check command in the manual OpenTP1 System Definition.
- aa....aa: Message type
- bb....bb: Problem identification code
- S: Continues processing.
- Countermeasure: Take either of the following actions:
- Either do not specify the name_rpc_control_list operand in the name service definition, or else specify Y for it.
- Specify 1 or 2 in the name_audit_conf operand in the name service definition.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.