OpenTP1 Version 7 Operation
stsfills (Display contents of a status file)
Format
stsfills -f physical-file-name [-cx] |
Function
The stsfills command outputs the contents of a status file to the standard output in the offline mode.
Options
-f physical-file-name~<path name>
Specifies the name of a physical file, expressed as the full path name.
-c
Specifies that the status file is to be checked. The following types of information are checked:
If the check reveals an inconsistency, the contents of the specified status file are displayed, and an error message is output.
When this option is omitted, the status file is not checked.
-x
Specifies that the status file is to be opened in the lock mode. If the stsfills command is lock at the time the status service is started, OpenTP1 may terminate abnormally with a lock error.
When this option is omitted, the status file is not opened in the lock mode. If the specified status file is being used by OpenTP1, the correct status may not be displayed.
Output format
Output messages
Message ID | Description | Output destination |
---|---|---|
KFCA01040-E | Error occurred in physical file. | Standard error output |
KFCA01070-E | Error occurred during stsfills command processing. | Standard error output |
KFCA01088-I | Help message | Standard output, standard error output |
KFCA01091-E | Memory is inadequate. | Standard error output |
KFCA01099-E | Error occurred during OpenTP1 function call. | Standard error output |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.