OpenTP1 Version 7 Operation

[Contents][Index][Back][Next]

namunavl (Forcibly invalidate the OpenTP1 start notification information)

Format

namunavl {-l|[-g]-n"node-name"[,"node-name"...]}

Function

The namunavl command forcibly invalidates start notification information from an instance of OpenTP1 that starts on the node specified in an option of this command. When you execute this command, a new connection is established and the system can communicate normally without receiving a startup notification from the communication destination.

Options

-l

Specifying this option outputs the IP address that could not receive a startup notification due to a communication error that occurred when OpenTP1 was started. Since startup is not notified to the output IP address, the instance of OpenTP1 that starts on that IP address may not be able to communicate normally. In that case, you need to execute the namunavl command in the instance of OpenTP1 that cannot communicate.

To check if a startup notification is prevented by a communication error, check whether the KFCA00642-W message is output in the system log.

-g

Specifying this option suppresses the output of a recheck message (KFCA00644-R).

-n "node-name"[,"node-name"...]~<identifier of 1 to 255 characters>

Specify the name of the node where OpenTP1 that invalidates the notified information (notification time) is to be started. You can neither omit this option, nor can you specify it more than once.

Notes