OpenTP1 Version 7 Operation
mcftedalt (Terminate alternate sending)
Format
mcftedalt [-s MCF-communication-process-identifier] -l logical-terminal-name |
Function
The mcftedalt command terminates alternate sending.
This command can be used under the TP1/NET/XMAP3 or TP1/NET/HNA-560/20 protocol.
Options
-s MCF-communication-process-identifier~<numerals (0-9), a-f> ((01-ef))
Specifies the MCF communication process identifier of the MCF communication service controlling the target logical terminal. No more than one MCF communication process identifier can be specified.
If this option is omitted, the mcftedalt command is executed on all MCFs. This means that the overhead required to search for the MCF communication services is added to the processing load of the operation commands.
If you want to have a configuration that includes lots of MCF communication services or if you want to use many operation commands, use the -s option to specify an MCF communication process identifier.
-l logical-terminal-name~<1-8 character identifier>
Specifies the name of the logical terminal which originates alternate sending. It must be the logical terminal name that is specified in the -f option of the mcftstalt command. Neither more than one name nor name of a group of service groups can be specified.
Output messages
Message ID | Description | Output destination |
---|---|---|
KFCA10117-I | Alternate sending of the message will terminate. | Standard output |
KFCA10350-I | mcftedalt command has been entered. | Standard output |
KFCA10351-E | MCF startup processing is underway. | Standard error output |
KFCA10352-E | MCF termination processing is underway. | Standard error output |
KFCA10353-W | Input format is invalid. | Standard error output |
KFCA10354-E | Memory is inadequate. | Standard error output |
KFCA10355-W | Specification of an argument is invalid. | Standard error output |
KFCA10356-E | Overtime occurred during process. | Standard error output |
KFCA10357-E | Overtime occurred in MCF. | Standard error output |
KFCA10358-E | Error occurred in an internal function. | Standard error output |
KFCA10359-W | Response to mcftedalt command input source failed. | Message log file |
KFCA10371-I | mcftedalt command has been accepted normally. | Standard output |
KFCA10373-E | mcftedalt command terminated abnormally. | Standard error output |
KFCA10380-E | Retrieval of remote process failed. | Standard error output |
KFCA10382-E | Specified logical terminal has not been cataloged. | Standard error output |
KFCA10542-I | Help message | Standard output |
KFCA16402-E | RPC error occurred during command processing. | Standard error output |
In addition to these messages, messages for the protocol being used are output; for details, see the applicable protocol manual.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.