OpenTP1 Version 7 Operation

[Contents][Index][Back][Next]

7.4.10 Nonswappable target file group

The user is required to make a standby-status file group available so that it can be readily used as a swap target. When swapping of a file group is needed because it becomes full or an error occurs during output of journals, OpenTP1 will terminate abnormally if there is no standby-status file group ready for use as a swap target.

If OpenTP1 terminates abnormally because of the absence of a swap target file group, it can be restarted by executing the jnlunlfg command that unloads the file group and removes an error with any file group. If an attempt to restart OpenTP1 fails, specify a new file group with ONL specified in the archive journal service definition and try restarting again.

If the archive source node goes down while the global archive journal service is running and the system journal has no swap target, perform the following: