mcfmsmsg [-m "[ID-of-message-not-to-output [ID-of-message-not-to- output]...]"]

Define this command when you want to suppress outputting log messages.

This command suppresses outputting the specified log messages (which are to be output to the standard output, the standard error output and the message log file). To specify the messages not to output, specify the message IDs in the -m option.

If a request to output a log message frequently occurs, the log service is heavily loaded and the processing may be delayed. Use the -m option to reduce the load on the log service.

-m "[ID-of-message-not-to-output [ID-of-message-not-to-output]...]" ~<unsigned integer> ((10000-19999 and 28000-29999))

Specify the IDs of the messages you do not want to output to the log file. You can use only message serial numbers (five-digit integer) to specify the messages. You can specify up to 50 IDs.

You cannot suppress outputting the following messages even if you specify them:

• Messages that are not output by MCF
• Messages output by the remote MCF manager (When the remote MCF service is used, the suppression of message output follows the definition in the message destination)
• MCF startup message
• Messages that are not output to the log file
• Messages output by definition commands and operation commands