KDKD10227-E


                        aa....aa

                                                Command parameter name

                                        
bb....bb

                                                Command parameter setting

                                        
                        Description
                        An invalid value is specified in the maximum number of the output
                                destination directory of the system information archive file.

                
                        Action
                        If you specify the same output destination directory for multiple nodes
                                in the following command parameters, specify the same value for the
                                maximum number of files that are output in the output destination
                                directory on each node.

                        
                                        hitachi-domain.hitachi-snapshot.output-dir

                                
                                        nodes.node.Node
                                                  name.hitachi-node.hitachi-node-snapshot.output-dir

                                
                        After specifying the value, run the subcommand again.