KDKD10223-E


aa....aa

                                                Server name

                                        
Description
The following are possible causes of the problem: 

                        
                                        The specified server does not exist.

                                
                                        An unnecessary server remains because an error occurs
                                                during the configuration of the server, when this
                                                message is displayed even if an existing server is
                                                selected.

                                
                        Action
                        
                                        Perform one of the following, based on the corresponding
                                                the cause and exception information.

                                                
                                                                If you have specified the server
                                                  name that does not exist, run the subcommand again
                                                  by specifying the name of the existing server.

                                                        
                                                                If this message is displayed even
                                                  if you specify the existing server, clean-up the
                                                  server, or delete the unnecessary server, and then
                                                  run the subcommand again. You can clean-up or
                                                  delete the server using the following
                                                  subcommands:

                                                                
                                                                                cleanup-prf

                                                                        
                                                                                cleanup-webserver

                                                                        
                                                                                delete-instance

                                                                        
                                                                If an error occurs when the above
                                                subcommand was run, delete the directory of the
                                                target server manually.