KDKD10146-E
Failed to establish a connection to the node. (details = aa....aa)
Description
An error occurred on the node while running the subcommand.
This message is displayed in the following conditions:
-
When the subcommand is run for the remote node, the required settings for SSH and DCOM have not been configured correctly on the node.
-
Unable to connect to the specified node.
Action
Perform one of the following, based on the corresponding cause displayed in the detailed information.
-
Verify whether the SSH and DCOM connections are configured correctly on the specified remote node, and then run the subcommand again.
-
Verify whether it is possible to connect to the specified node, and then run the subcommand again.