KDKD10139-E

aa....aa

                        Detailed information

Description
An error occurred on the node, when the subcommand was run for the Domain Administration Server
                (DAS).

This message is displayed in the following conditions:

                    When the subcommand is run on the remote node, the required settings for SSH
                        and DCOM connections have not been configured correctly on the node.

Unable to connect to the specified node.

Action
Perform one of the following, based on the corresponding cause displayed in the detailed
                information.

                    Verify whether the SSH and DCOM connections are configured correctly on the
                        specified remote node, and then run the subcommand again.

                    If the details include errorCode: 0xC00000AC while
                            attempting to run this command, make sure the Remote Registry
                        Service runs on the remote node. If the Remote Registry Service on the
                        remote node stops, make sure the service is set to start up automatically,
                        start the service, and then retry the sub-command.

Verify whether it is possible to connect to the specified node, and then run the subcommand
                        again.