2.3.171 Timeout

Description

Timeout specifies the following wait time in seconds. If 0 is specified, the wait time becomes 0 seconds.

• Wait time when data cannot be received during reception of a request from a client (after a connection is established, during reception by the HTTP protocol)

• Wait time when data cannot be sent during the sending of a response to a client

• Wait time when data cannot be sent during the sending of a request to a CGI program

• Wait time until the response is received after a request is sent to a CGI program

• Wait time when data cannot be received during reception of a response from a CGI program

• Wait time until the pipe is closed for input and output after a response is received from a CGI program.

• Wait time when data cannot be sent during the sending of a request to the backend server, when a reverse proxy is used.

• Wait time until the response is received after a request is sent to the backend server, when a reverse proxy is used.

• Wait time when data cannot be received during reception of a response from the backend server, when a reverse proxy is used.

The ProxyTimeout directive value takes priority over the wait time for transmission to or from the backend server when a reverse proxy is used.

Syntax

Timeout time

Specifiable values

0 to 65,535

Default value

If the definition item is omitted:

60

Location where it can be written

httpsd.conf

Timeout 300