Hitachi

JP1 Version 12 JP1/SNMP System Observer Description, Operator's Guide and Reference


3.5.1 Setting a community name

To enable communication with SSO, you need to set the community name. To set the community name, follow the procedures shown below.

Organization of this subsection

(1) In Windows

With the SNMP Security Configuration of the SNMP Service service, set the community name.

For the community's permission levels, specify the READ_WRITE or READ_CREATE privilege. In addition, you must configure the community so that it can accept SNMP packets from the SSO.

(2) In UNIX

To set a community name, specify the Get and Set community names in /etc/SnmpAgent.d/snmpd.conf as appropriate to the environment in use.