2.3.1 Locking user accounts
You can specify that a user's account is to be locked when the user fails to log in to JP1/IT Desktop Management 2 a predetermined number of times. That user cannot log in again until the user account is unlocked.
When ITDM2 certification is used, You can specify the number of failed attempts before a user account is locked, in the Other Settings view in the setup window.
When using IDaaS linkage, rule of locking user accounts depends on the settings of the ID provider. Value set in the Other Settings view in setup window is ignored.
You can find out whether any accounts are locked by accessing the Account Management view in the Settings module from a user account with user management permission. You can then use the same view to unlock the account.
Disabled appears as the Status of locked user accounts in the Account Management view.
- Tip
-
If there are no accounts with user management permission, unlock the account by restarting the management server.