6.10 Notes on Web GUI
This section describes notes on the use of the Web GUI.
- About OS limitations on command lines
-
When the execution host of service linkage jobs is on Windows, the number of characters that can be used is approximately 8,000 because there is a limitation on OS command lines.
- Input value restrictions
-
Multibyte input characters, if included, are counted with the value calculated with the number of UTF-8 bytes. The number of characters cannot be input to fields other than number input fields. Therefore, enter a value while considering the number of UTF-8 bytes if multibyte characters are included.
- When an input value includes control characters
-
Delete control characters when performing registration on each definition screen or outputting a file on the service linkage job definition screen. The control characters to be deleted are as follows: 00 to 1F, 7F to 9F, and Unicode control characters (\u200E, \u200F, \u200D, \u200C, \u202A, \u202D, \u202E, \u202C, \u206E, \u206F, \u206B, \u206A, \u206D, \u206C, \u001E, \u001F, \u202B).
Note that 0A (LF) and 09 (tab character) are not deleted from some input items. For those input items where these control characters are not deleted, refer to the input value restrictions of each definition screen.
The available number of characters does not include control characters because, as described above, they are deleted when the number of input characters is counted.
- Operation at the time of exporting or importing
-
When data are exported while being input, the inputs to the screen at the time of export may not be shown on the screen.
Specifically, check the following after importing.
-
When the data is exported with only an environment variable name input for the Environment variables at time of command execution on the execution definition screen and connection definition screen, environment-variable-name= is displayed on the screen when the data are imported.
-
When the data is exported with only = input for the Environment variables at time of command execution on the execution definition screen and connection definition screen, a blank line is displayed on the screen when imported.
-
When the data are exported and then imported with the Connection definitions item selected but no definition selected on the Service linkage job definitions screen, the item is not selected on the screen.
-