9.1 Error handling procedures
This section describes the procedures for handling errors that might occur while you are using JP1/FTP.
-
Check the processing.
Check the processing event that was underway when the error occurred. If a message has been output, check the details of the message (for the messages, see 8. Messages). For details about the log information that is output by JP1/FTP, see 9.2 Types of log information.
-
Collect data.
Collect data to determine the cause of the error. For details about the data to be collected, see 9.3 Data to collect when a problem occurs.
-
Check the problem.
Check the cause of the problem on the basis of the collected data. Also isolate the problem or the affected range.