KAJM0110-W
An attempt to convert the character code failed.
An attempt to convert the character code failed.
- (S)
-
The system continues with command execution.
- (O)
-
Take either of the following actions.
-
If there is a subsequent message:
An attempt to convert the character code for the subsequent message failed. Check the contents of the subsequent message.
-
If this message is output after the SAP system information is displayed by the jr3bjrep and jr3bjsho commands:
An attempt to convert the character code failed because the displayed SAP system information contains a character code that does not belong to the Shift-JIS encoding supported by the command. Check the information on the SAP system.
-