KNAD3624-E
An attempt to create a process management table has failed.
An attempt to create a process management table has failed.
The probable causes are:
-
System memory is insufficient.
-
Necessary products have not been installed correctly.
-
The scheduler service and embedded database have not been set up correctly.
-
There are errors in the extended startup process definition file or environment setting parameters.
-
A managed process that was previously started remains in the system.
- (S)
-
Terminates the system management command.
- (O)
-
-
Check whether there is a system memory shortage and whether the product has been installed correctly.
-
If automatic setup of the scheduler service and embedded database was skipped when JP1/AJS3 was installed as a new installation, complete setup of the scheduler service and embedded database.
-
Check whether the settings in the extended startup process definition file (jp1ajs_xxxx_0700.conf) have been specified correctly. xxxx represents service, dbmd, hstd, agtd, or schd.
-
Make sure that all processes that were managed last time have terminated normally and none of the processes remain in the system.
If any managed processes remain, forcibly terminate all of them, and then restart the service.
-
Check whether the KAVS2128-E message was output to the Windows event log (in Windows) or syslog (in UNIX).
If the KAVS2128-E message was output, setup of the scheduler service has failed, in which case take the corrective action suggested in the message.
-
If the environment setting parameters are specified by using the jbssetcnf command, make sure that the specified definition key and environment setting parameters are correct. If the settings are not correct, restore the original settings (before the change) from the backup, and then correct the settings. If there is no backup, install JP1/AJS3 again, and then set the environment setting parameters.
-