1.5.5 Commands used to operate execution agents
The following table lists the commands used to operate execution agents.
Table 1‒11: Commands used to operate execution agents
Function
|
Command name
|
Windows
|
UNIX
|
Required privileges
|
Supported products
|
Adds an execution agent.
|
ajsagtadd
|
Y
|
Y
|
JP1_JPQ_Admin
|
M
|
Deletes an execution agent.
|
ajsagtdel
|
Y
|
Y
|
JP1_JPQ_Admin
|
M
|
Outputs information such as the job execution status on an execution agent to the standard output.
|
ajsagtshow
|
Y
|
Y
|
JP1_JPQ_Admin
JP1_JPQ_Operator
JP1_JPQ_User
or
Windows: Administrators
UNIX: Superuser
|
M
|
Changes the execution agent settings or the job transfer restriction status.
|
ajsagtalt
|
Y
|
Y
|
JP1_JPQ_Admin
JP1_JPQ_Operator
|
M
|
Starts and stops a communication status check for an execution agent, and outputs the status of the execution agent to the
standard output.
|
ajsagtcheck
|
Y
|
Y
|
Windows: Administrators
UNIX: Superuser
|
M
|
Outputs execution agent definition information in CSV format to the standard output file.
|
ajsagtprint
|
Y
|
Y
|
JP1_JPQ_Admin
JP1_JPQ_Operator
JP1_JPQ_User
or
Windows: Administrators
UNIX: Superuser
|
M
|
Outputs a list of event jobs being executed by an execution agent to the standard output.
|
jpoagtjobshow
|
Y
|
Y
|
Windows: Administrators
UNIX: Superuser
|
M and A
|
Outputs, to the standard output, information indicating whether the agent is set up as a destination agent at the broadcast
destination or as a broadcast agent.
|
ajsfxbcstatus
|
Y
|
Y
|
None
|
M and A
|
- Legend:
-
Y: Supported
M: JP1/AJS3 - Manager
A: JP1/AJS3 - Agent
- Note
-
On a Windows host, before you execute a command that must be executed by a user with administrator privileges, make sure that
you open the Command Prompt window as an administrator. If the UAC function is disabled, you do not need to open the Command
Prompt window as an administrator.
To Page Top