C.7 Environment setting parameters whose defaults were changed to recommended values in version 13-10
This section describes the environment setting parameters for which defaults were changed to recommended values in JP1/AJS3 version 13-10.
The table below describes the actions to be taken and the conditions to be applied due to the use of the defaults (recommended values) in version 13-10 or later. Using the information as criteria, determine whether to use defaults for operation, and change parameter settings as needed.
- Organization of this subsection
(1) Environment settings related to event/action control
The table below lists the environment setting parameters (among those related to event/action control) for which defaults were changed to recommended values in JP1/AJS3 version 13-10.
- Cautionary note:
-
In the case of performing an upgrade installation to upgrade JP1/AJS3 version 13-00 or earlier to JP1/AJS3 version 13-10 or later, the defaults of the environment setting parameters of the old version are inherited by the new version. Review the settings to change them to recommended values.
|
No. |
Definition key |
Environment setting parameter |
Default in version 13-00 or earlier |
Default in version 13-10 or later |
Operation and conditions of using the defaults in version 13-10 or later |
|---|---|---|---|---|---|
|
1 |
JP1_DEFAULT\JP1AOMAGENT |
"ClientConnectTimeout" |
In Windows: None In UNIX: None |
In Windows: None In UNIX: dword:00002710 |
The maximum time during which the agent host can wait until connection to the manager host succeeds when operating an event job in a UNIX environment is set to 10,000 milliseconds (10 seconds). For details, see 20.6.2(25) ClientConnectTimeout (event/action control). |
|
2 |
JP1_DEFAULT\JP1AOMAGENT |
"NotificationAlarmCount" |
--# |
In Windows: dword:00000013 In UNIX: dword:0000001D |
When an agent host attempts to communicate with the manager host for operating an event job, if the attempt fails for the specified number of times in succession, the KAVT0669-E message is output. For details, see 20.6.2(27) NotificationAlarmCount. |
- #
-
Because the environment setting parameter was added in version 13-10, no value is set, but the product behaves as if dword:00000000 is set.