15.7.2 Settings for the execution agent performance report output function

JP1/AJS3 provides the execution agent performance report output function, which outputs a report on the job execution states of execution agents, for the user to properly understand the work volume in the JP1/AJS3 system. The following procedure describes how to enable the execution agent performance report output function.

Organization of this subsection

(1) Definition procedure

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
Execute the following command to set the environment setting parameters described in (2) below:
```
jajs_config -k definition-key "parameter-name"=value
```
Restart JP1/AJS3.

The contents of the configuration file are applied to the system.

To Page Top

(2) Environment setting parameters

Table 15‒75: Environment setting parameters for setting up the execution agent performance report output function
Definition key	Environment setting parameter	Explanation
[{JP1_DEFAULT\|`logical-host-name`}\JP1AJSMANAGER]^#	"AJSAGTREPORTUSE"=	Enables or disables the execution agent performance report output function.
	"AJSAGTREPORTDIR"=	Specifies the directory to which execution agent performance log files are to be output.
	"AJSAGTREPORTSTOREDAYPERIOD"=	Specifies the minimum retention period (in days) for execution agent performance log files.

#:: The specification of the {JP1_DEFAULT|logical-host-name} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of these environment setting parameters, see the following:

To Page Top