15.1 Settings for controlling the scheduler

This section describes how to change the settings for controlling the scheduler.

When you set environment setting parameters, use the jajs_config command.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference.

Organization of this section

• 15.1.1 Settings for starting multiple scheduler services

• 15.1.2 Changing the level of messages output from scheduler services to the integrated trace log

• 15.1.3 Changing the method for outputting the schedule rule when outputting nested-jobnet definition parameters

• 15.1.4 Changing the name of a scheduler trace log file

• 15.1.5 Setting to output a scheduler trace log per scheduler service

• 15.1.6 Enabling the suspend function

• 15.1.7 Changing the mode in which unregistration or generation management deletes the generations of a jobnet

• 15.1.8 Settings for using wait conditions

• 15.1.9 Settings for using the temporary change operation management function

• 15.1.10 Setting for changing the number of characters specifiable for a unit name in a UTF-8 environment

• 15.1.11 Settings for preventing scheduler services for which the user does not have access permission from appearing in JP1/AJS3 - View

• 15.1.12 Settings for restricting the maximum number of allowed concurrent sessions for scheduler services

• 15.1.13 Setting to reduce the number of ports used for internal communications by the scheduler service at job execution

• 15.1.14 Settings to change the last schedulable year for jobs

To Page Top