13.2.2 Setting up JP1/AJS3 - Agent
This subsection describes how to set up JP1/AJS3 - Agent. Before you set up JP1/AJS3 - Agent, make sure that you have superuser permissions.
Make sure that JP1/Base has already been set up before you attempt to set up JP1/AJS3 - Agent.
Make sure that the umask for the user who starts JP1/AJS3 permits viewing and updating by any user who executes JP1/AJS3 commands.
Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.
|
Topic |
Reference |
|---|---|
|
Procedure for setting environment setting parameters |
|
|
Procedure for restricting connections to JP1/AJS3 |
|
|
Settings for defining the work path to be used during job execution as a variable |
|
|
Changing the timeout value for pipe communication of the agent |
|
|
Setting the timeout value for receiving notification from the job process that execution is ready |
|
|
Changing the settings related to the size of the log for event jobs and custom event jobs to match operational requirements |
|
|
Setting the status passing option for the file monitoring job |
|
|
Settings for automatic startup and termination of the JP1/AJS3 service |
|
|
Settings for the JP1/AJS3 definition pre-check function |
|
|
Settings for using the Web GUI (Management Portal) |
|
|
Settings for logging |
|
|
Setting up for a cluster system |
- Organization of this subsection
(1) Setup procedure
To set up JP1/AJS3 - Agent:
-
If necessary, change the environment setting parameters.
Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.
For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference. For details on the jbssetcnf command, see the JP1/Base User's Guide.
-
Set up the system and user environments.
For details about setting up the system and user environments, see 13.4 Setting up the system and user environments.
-
If necessary, set the method for automatic startup and termination of the JP1/AJS3 service.
For details about setting the method for automatic startup and termination of the JP1/AJS3 service, see 15.10.1 Setting automatic startup and termination of the JP1/AJS3 service.
JP1/AJS3 - Agent setup is complete.