D.4 Setting the AJS administrator
To set the AJS administrator:
-
Specify the OS user you created for the AJS administrator for the JP1AJS3_ADMINUSR_NAME environment variable.
-
Install JP1/AJS3.
For details about the installation procedure, see 12.2 Installing JP1/AJS3 series programs.
-
Execute the jajsshowadminusr command and confirm that the AJS administrator was set correctly.
For example, execute the jajsshowadminusr command as follows:
# /opt/jp1ajs2/bin/jajsshowadminusr
For details about the jajsshowadminusr command, see jajsshowadminusr (UNIX only) in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
If you use the system in a cluster configuration or use a disaster recovery operation, make sure that the following values are the same for the primary node and the secondary node, and for the main site and the remote site:
-
Name of the OS user group for the JP1 administrators group
-
Group ID of the OS user group for the JP1 administrators group
-
Name of the OS user for the AJS administrator
-
User ID of the OS user for the AJS administrator
-