14.2.1 Procedure for setting the environment setting parameters by using the jajs_config command
To use the jajs_config command to change the settings in the common definition information:
-
Stop the JP1/AJS3 service.
Execute the following commands to confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop#1 # /opt/jp1ajs2/bin/jajs_spmd_status
- #1:
-
Confirm that automatic termination has been set.
-
Change the settings in the common definition information.
Use the following command to specify new environment setting parameter settings in the common definition information:
jajs_configΔ-kΔ"definition-key"Δ"parameter-name-1"=value-1Δ["parameter-name-2"=value-2] ...
- Legend:
-
Δ: One-byte space
Example:
jajs_config -k "[JP1_DEFAULT\JP1AJSMANAGER\AJSROOT1]" "LOGSIZE"=dword:00002800 "AJSLOG"="all"
-
Restart JP1/AJS3.
The changes in the common definition information are applied to JP1/AJS3.
- Supplementary note:
-
You can specify only one definition key for definition-key. To set environment setting parameters that have different definition keys, run the jajs_config command for each definition key, or use the jbssetcnf command.