6.3.20 TCP agent definition file (ssotcpagent.conf)
In the TCP agent definition file, define the APM to be a target of TCP health check.
- Organization of this subsection
(1) Format
In a TCP agent definition file, specify the definition for each agent on a line. Delimit each definition item with a colon (:). Note the following when creating the TCP agent definition file:
-
The TCP health check is performed for a specified agent only when the version of the APM on the specified agent is 08-00 or later. For other agents, the health check by using SNMP (UDP) is performed as normal.
-
If no TCP agent definition file is found in the $SSO_CONF directory, the health check by using SNMP (UDP) is performed for all agents as normal.
-
If the definition file includes multiple definitions for the same agent, the definition written first is assumed to be valid, and the other definitions are ignored. Therefore, if a definition specifying *.*.*.* as the IP address of the monitoring target agent is written at the top of the definition file, that definition applies to all agents.
-
To apply updates in this definition file, restart the ssoapmon daemon process or execute the ssoapcom -r command.
(2) Details of definition
|
Item |
Value |
|---|---|
|
IP-address |
Specify the IP address of the monitoring target agent in the n.n.n.n format. For n, you can specify a value from 0 to 255 or an asterisk (*) or question mark (?) as a wild card. |
|
port-number <<20307>> ((1 to 65535)) |
Specify the port number to be used to perform the health check for the monitoring target agent. |
|
response-monitoring-time <<50>> ((10 to 36000)) |
Specify the response monitoring time during the health check for the monitoring target agent. Specify the time in units of 1/10 second. |
|
retry-count <<1>> ((0 to 99)) |
Specify the number of retries to be attempted when the health check on the monitoring target agent fails. |
(3) Example
The following shows an example of a TCP agent definition file.
![[Figure]](GRAPHICS/SS07E000.GIF)