13.5.4 Monitoring configuration for static NAT
Depending on your network environment, the NNMi administrator can select the ICMP fault monitoring settings to be used. See also 13.6.7 NNMi calculations for state and status.
Monitoring Configuration > Node Settings tab
Configure monitoring for a node group. In this case, make your choices in the ICMP Fault Monitoring section. For details, see NNMi online Help.
Management address polling (enabled by default and highly recommended)
IP address fault polling (optional)
Monitoring Configuration > Default Settings tab
In this case, make your choices in the ICMP Fault Monitoring section. For details, see NNMi online Help.
- Important
If your network environment also includes any dynamic NAT domains, default settings might not be appropriate because you might want different settings for the static NAT domains from those for the dynamic NAT domains.