7.3.2 Configuring interface monitoring
State Poller analyzes interface group membership before node groups. For each of the interface groups you created, as well as any pre-existing ones you want to use, open the Monitoring Configuration form and the Interface Group Settings tab to create a custom set of instructions for how you want State Poller to handle that group. Your instructions will include the following:
Enabling or disabling fault monitoring
Setting the fault polling interval
Selecting whether NNMi will monitor unconnected interfaces (or unconnected interfaces hosting IP addresses) in the group
You can configure different settings for each interface group. Remember that the State Poller evaluates the list in order from the lowest ordering number to the highest ordering number.
- Tip
Double-check your order numbers, keeping in mind that an object that qualifies for multiple groups has settings applied from the group with the lowest order number.