KNAE08159-E

Processing was interrupted because an error occurred during the file-transfer processing (connection target: {0}, local file path: {1}, remote file path: {2}, details: {3}).

[Cause]

Possible causes are as follows:

(1) A file read or write error occurred on the destination host.

(2) The name of the source or destination file exceeds 127 characters.

(3) When a folder was assigned for the source or destination, the absolute path of one or more files and folders exceeded 256 characters.

(4) When a folder was assigned for the source or destination, one or more paths after the assigned folder exceeded 127 characters.

(5) A network drive was specified for the remote file path.

(6) A UNC path was specified for the remote file path.

(7) A connection error occurred during the transfer.

(8) The destination host is overloaded.

(9) A file to be transferred is encrypted.

(10) The file transfer protocol is disabled on the destination host.

(11) The destination host is not running.

(12) The destination host was rebooted during the connection.

[Action]

Check the following, and then run the service again:

(1)-(6) Make sure the path of the source, destination file, and folder are correct.

(7) Make sure there are no errors on connection route to the destination host.

(8) Make sure the destination host is not overloaded.

(9) Make sure that none of the files to be transferred are encrypted.

(10) Make sure the file transfer protocol is enabled on the destination host.

(11)-(12) Make sure the destination host is running.

If the problem persists, collect log information, and then contact a system administrator.

0: Host name or IP address of the destination host

1: Local path

2: Remote path

3: Detailed information