2.2.17 Status code
The following table describes the various status codes that can be returned when an API is executed. The status codes to be returned depend on the API, so see the description for each API for details.
Status code |
Message |
Description |
---|---|---|
200 |
OK |
Processing the request has been successfully completed. |
201 |
Created |
If creation of a resource ended successfully, status 201 is returned instead of status 200. |
400 |
Bad Request |
The content of the request is invalid. |
401 |
Unauthorized |
Authentication failed. Authentication information or permission information is invalid. The accepted authentication method is reported by the WWW-Authenticate response header. Specify the accepted authentication method in the Authorization request header. Alternatively, the user does not have a permission for the service group or the User Management permission. |
403 |
Forbidden |
The user does not have execution permission for the request. |
404 |
Not found |
The requested resource does not exist, or the user does not have permission to operate the requested resource. Alternatively, a specified query parameter is invalid. |
405 |
Method not allowed |
The requested method does not exist for this resource. |
406 |
Not acceptable |
The format of the specified response is not supported. |
409 |
Conflict |
The request cannot be completed because the data conflicts with data that already exists on the server, or because the system cannot accept the request in the current status. |
412 |
Precondition failed |
The request cannot be accepted because it does not satisfy requirements. |
415 |
Unsupported media type |
The format of the specified request is not supported. |
500 |
Server-side error |
A server processing error occurred. |