1.3 Valid characters for arguments in a command
This section describes the valid characters for arguments in a command.
You can specify arguments in a command according to the specification of the OS command prompt and shell. Therefore, if an argument contains any spaces or special characters, you must escape the argument by, for example, enclosing it in double quotation marks (").
The following characters are available when you specify a path argument in each command:
Half-width alphanumeric characters, _, ., -, (space), (, ), #, @, :, \
However, there are no limitations on the path to be specified in the propertyfile option of the submittask command.
Note that, if the JP1/AO server OS is Linux, / can also only be used to separate folders.
If the JP1/AO server OS is Windows, : can only be used to separate the drive letter.
If the JP1/AO server OS is Windows, \ can only be used to separate folders.
You cannot specify a path in the UNC format when specifying the path as an argument.
You cannot use a path whose folder name is preceded or followed by a space character when specifying the path as an argument. Also, you cannot use a folder name that only has the space characters.
You cannot use a path whose folder name is preceded or followed by a period (.) when specifying the path as an argument. Also, you cannot use a folder name that only has the periods.
Unless otherwise specified, you can use 1-230 characters for the absolute path.
Unless otherwise specified, arguments for each command are case sensitive.
The names shown below are reserved keywords in the OS. Do not use them for file and folder names.
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1, COM2, COM3, COM4, COM5, COM6, COM7, COM8, COM9, LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7, LPT8, LPT9