6.1.8 Setting a specific character set during plug-in execution
If you want the JP1/AO server to use a specific character set for communication when performing an operation on a UNIX device, enter the appropriate setting in a character-set mapping file, or in the terminal.charset key of a connection-destination property file.
If you specify a character set in a character-set mapping file and in the terminal.charset key of a connection-destination property file, the character set is assigned in the order of priority shown in the following table.
Priority |
Setting |
---|---|
1 |
Character set specified in the terminal.charset key of the connection-destination property file |
2 |
Character set specified in the character-set mapping file |
3 |
Character set returned by the locale charmap command on the operation target device |
4 |
UTF-8 |