JP1 Version 13 JP1/Automatic Operation Configuration Guide
Contents
Glossary
Index
Previous
85 / 158
Next
Cover
5. Setting up a cluster system
This chapter describes how to set up a JP1/AO cluster system.
5.1 Procedure for installing JP1/AO in a cluster system
5.2 Installation prerequisites (for cluster systems)
5.3 Installing JP1/AO in a cluster system
5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)
5.5 Cluster settings file (cluster.conf)
5.6 Folders created on the JP1/AO shared disk
5.7 Cluster service control commands to be registered in the cluster software
To Page Top