KAVB3751-E
The process stopped in response to the signal. pid = process-ID. signal = signal-number.
The management-target process stopped in response to the signal. process-ID is the process ID of the management-target process that was being started. signal-number is the number of the signal that causes the process to stop.
- (S)
-
Continues processing.
- (O)
-
Check the integrated trace log output by the management-target process that was terminated anbormally, and eliminate the cause of the error. Use the jbs_spmd_status command to check the status, and then restart the process management. If the management-target process did not output any messages, use the data collection tool to collect data, and then contact the system administrator.